Welcome to the website of Hebei Shengyi Plastic Technology Co., Ltd.
FAQs on Sealing Strip Installation
Release time:
2024-01-26
Silicone rubber sealing strip can not be pulled too tight, laser cutting length than the installation length of 2-3cm. When installing, it should be embedded in time, the surface layer should be vertical, and it should be closely contacted with the laminated glass and the laminated glass slot hole, so that the surrounding of the laminated glass can bear the force evenly.
1. silicone rubber sealing strip can not be pulled too tight, laser cutting length than the installation length of 2-3cm. When installing, it should be embedded in time, the surface layer should be vertical, and closely contact with laminated glass and laminated glass slot holes, so that the peripheral bearing force of laminated glass is symmetrical. At the corner, use the slope to disconnect the sealing strip, and the broken part is glued firmly.
2. When fixing the laminated glass with sealant, first use vulcanized rubber strip or vulcanized rubber block to squeeze the laminated glass, and make a gap for glue injection. The deep layer of glue filling shall not be less than 5mm. Laminated glass shall remain vibration-free before the superglue sets. Improve the sound card rack and centrifugal fan in the middle of the sealing.
3. The top specification model is the key element that endangers the characteristics and tightness of moving doors and windows, and is also the key element that endangers the opening and closing force of windows and doors. If the wall top size is too large or the vertical wall top is too high, not only the installation is difficult, but also the moving friction resistance of the window door will continue to be lifted, especially the original friction resistance when opening and the friction resistance when closing.
4. If the specification is too small, or the height-to-width ratio of the vertical top is insufficient, it is very easy to climb out of the concave groove, which greatly reduces the sealing characteristics of the window and door. The top should be siliconized. The surface layer of the wall top that meets the standard shall be vertical, the bottom plate and vertical hairs shall be smooth and free of bending, and the bottom plate shall be free of black spots, which shall meet the requirement of 0.2mm.
Keywords:
More information
Hebei Shengyi Plastic Technology Co., Ltd.
The company specializes in producing various materials such as composite extrusion, monomer extrusion, rubber plastic product docking molding, injection molded parts, molded parts, EPDM rubber sealing strips, foam rubber strips, PVC sealing strips, high-temperature resistant silicone strips, and various door and window sealing strips.
